Fallout Vault Boys Wrapping Paper: Retro Gift Wrap Steps

By Trick or Treat Studios-Trick Or Treat Studios | Published: 2026-11-05

Category: How-to Guides

Turn Fallout Vault Boys wrapping paper into retro gaming gift wrap with a clean, fan-worthy finish. Follow these steps for crisp folds and a polished presentation.

Quick answer

Wrap your gift with the printed side facing out, cut only enough paper to cover the box plus a 2–3 inch overlap, and crease every fold firmly with your thumbnail. This keeps the Vault Boy design centered and avoids bulky, torn corners.

Why the paper’s tube packaging matters for a clean wrap

Fallout Vault Boys Wrapping Paper arrives wrapped on a tube, which helps prevent creases and makes it easier to unroll a flat, even length. Cut the paper while it is still on the tube or immediately after unrolling, rather than letting it curl on the floor. A flat sheet is the difference between sharp corners and a lumpy finish.

When a retro look needs restraint

The Vault Boy print is already busy, so skip patterned ribbons, novelty bows, or multiple washi tapes. A solid-color ribbon, a simple tag, or a small Vault Boy sticker lets the wrapping paper carry the theme. If you are wrapping several Fallout themed presents, vary only the ribbon color to keep the set cohesive without competing with the design.

Step-by-step: wrap a Fallout gift with Vault Boys paper

Measure and cut with an overlap: Place the box face-down on the unrolled paper and bring the long edges together. Cut so the paper wraps around the box with 2–3 inches of overlap on each side. Common mistake: cutting flush to the box, which leaves no room to fold and creates gaps. Check the overlap before cutting; extra paper is easier to trim than to add.
Center the Vault Boy design: Before taping, slide the box so a clear Vault Boy figure sits on the top face or the most visible side. If the print repeats, choose a section with a full figure rather than a cropped edge. Common mistake: wrapping first and discovering the main character is split across a fold. Lay the box on the paper and preview the top face before any tape goes down.
Fold and crease the long seam: Bring the long edges to the center of the box, fold under a 1/2-inch hem for a clean edge, and press the seam flat with your thumbnail. Tape the seam down. Common mistake: taping a loose, uncreased seam that bulges when the gift is handled. Run your thumbnail along every fold; a sharp crease holds better than extra tape.
Fold the ends into tidy triangles: At each short end, push the paper flat against the box side, fold the top and bottom flaps inward to form triangles, then fold the point up and tape. Common mistake: folding the end like a paper bag, which leaves a thick lump under the box. Crease the triangle edges before taping so the end lies flat.
Add one simple finish: Tie a solid-color ribbon around the box or add a small gift tag. Keep the Vault Boy print visible; do not cover the main figure with a large bow. Common mistake: layering multiple patterned ribbons that hide the wrapping paper design. If the bow covers the main Vault Boy figure, move it to a corner or skip it.

Product facts

Fallout - Vault Boys Wrapping Paper: Premium weight wrapping paper on a convenient tube. The heavier sheet resists tearing at corners, and the tube keeps the roll flat between wrapping sessions.
Fallout - Vault Boys Wrapping Paper